Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

CHECKING THE STARTER MOTOR 1.Inspect: Commutator Dirty Clean it with #600 grit sandpaper. 2.Measure: Commutator diameter a Out of specification Replace the starter motor. Outside diameter: 28 mm (1.10 in) 27 mm (1.06 in) 3.Measure: Mica undercut b Out of specification Scrape the mica using a hacksaw blade. NOTE: Scrape the mica to the proper measurement using a hacksaw blade which has been grounded to fit the commutator. 4.Inspect: Armature coil (insulation/continuity) Defects Replace the starter motor. ***************************************************** Inspection steps: Connect the pocket tester for the continuity check 1 and insulation check 2 . Measure the armature resistances.

Armature coil resistance: Continuity check 1 : 0.025 ~ 0.035 Ω at 20 °C (68 °F) Insulation check 2 : More than 1 M Ω at 20 °C (68 °F) If the resistance is incorrect, replace the starter motor. ***************************************************** 9 - 22 ELECTRIC STARTING SYSTEM ELEC – + Mica undercut: 0.7 mm (0.03 in)