5.Measure: Brush length a (each) Out of specification Replace the brush. Brush length: 12.5 mm (0.49 in) 5 mm (0.20 in) 6.Measure: Brush spring force Fatigue/out of specification Replace as a set. Brush spring force: 7.65 ~ 10.01 Nm (780 ~ 1,020 g, 27.5 ~ 36.0 oz) 7.Inspect: Oil seal Bushing O-rings Wear/damage Replace. ASSEMBLING THE STARTER MOTOR 1.Install: Brush seat 1 1 NOTE: Align the projection a on the brush seat 1 with the slot b on the yoke. 2.Install: Yoke Brackets NOTE: Align the match marks a on the yoke with the match marks b on the brackets. 9 - 23 ELECTRIC STARTING SYSTEM ELEC – +