Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

CHARGING SYSTEM EB804012 Replace the rectifier/regulator. 9 - 26 ELEC – + Start the engine and accelerate to about ● 3,000 r/min. MEETS SPECIFICATION Charging voltage: 14 V at 1,000 r/min NOTE: Use a fully charged battery. The charging circuit is not faulty. The charging circuit is not faulty. OUT OF SPECIFICATION 4.Charging coil resistance OUT OF SPECIFICATION Disconnect the AC magneto coupler from ● the wire harness. Connect the pocket tester (Ω × 1) to the ● charging coils. Tester (+) lead → White terminal 1 Tester (–) lead → White terminal 2 Tester (+) lead → White terminal 1 Tester (–) lead → White terminal 3 Measure the stator coil resistance. ● Charging coil resistance:

0.32 ~ 0.43 Ω at 20 °C (68 °F) Replace the pickup coil/stator assembly. Replace the pickup coil/stator assembly. EB804015 MEETS SPECIFICATION 5.Wiring connections Check the connections of the entire charg- ● ing system. Refer to “CIRCUIT DIAGRAM”. Properly connect the charging system. CORRECT Properly connect the charging system. CORRECT