Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

7.If the coolant temperature indicator light does not come on when the main switch to “ON”, or if the coolant temperature indicator light does not come on when the temperature is high (more than 107 ~ 113 °C (224.6 ~ 235.4 °F)): 1.Coolant temperature indicator light LED NO CONTINUITY Check the LED of the coolant indicator light. Refer to “CHECKING THE LEDs”. Replace the meter assembly. CONTINUITY BAD CONDITION Replace the thermo switch 1. GOOD CONDITION * 9 - 42 SIGNAL SYSTEM ELEC – + 2.Thermo switch 1 Remove the thermo switch 1 from the cyl- ● inder head. Connect the pocket tester (Ω × 1) to the ● thermo switch 1. Immerse the thermo switch 1 in coolant 2.

● Check the thermo switch 1 for continuity. ● While heating the coolant use a thermome- ter 3 to record the temperatures. Test step Water temperature Good condition Thermo switch 1 1 0 ~ 103 °C (32 ~ 217.4 °F) × 2 More than 110 ± 3 °C (230 ± 5.4 °F) 3* 110 ~ 103 °C (230 ~ 217.4 °F) 4* Less than 103 °C (217.4 °F) × Tests 1 & 2; Heat-up tests Tests 3* & 4*; Cool-down tests : Continuity × : No continuity WARNING Handle the thermo switch 1 with special care. Never subject it to a strong shock or allow it to be dropped. Should it be dropped, it must be replaced. WARNING WARNING Thermo switch 1: 8 Nm (0.8 m • kg, 5.8 ft • lb) T. Three bond sealock® #10 R.