ADJUSTING THE STARTER CABLE/ CHECKING THE SPARK PLUG ADJUSTING THE STARTER CABLE 1.Remove: Seat Fuel tank side panel (left) 2.Adjust: ***************************************************** Adjustment steps: Disconnect the starter cable 1 from the car- buretor body. NOTE: Do not remove the starter plunger 2 from the starter cable. Measure the starter plunger stroke distance a of the starter lever 3 fully close to fully open position. If the distance is out of specifi- cation adjust it as described below. И Fully closed position Й Fully open position Pull back the boot 4 . Loosen the locknut 5 . Turn the adjuster 6 in or out until the correct distance is obtained. Tighten the locknut 5 .
Push in the boot 4 . Connect the starter cable to the carburetor. WARNING After adjusting the cable, turn the handle- bar to right and left, and make sure that the engine idling speed dose not increase. ***************************************************** 3.Install: Fuel tank side panel (left) Seat 3 - 21 CHK ADJ CHK ADJ Starter plunger stroke distance: 15 mm (0.59 in) Turning in Distance increased. Turning out Distance decreased.