volvo — page 53

Fuel system Adjustment of injection angle Use a scrapped fuel pipe. The pipe makes it easier to see when the fuel begins and stops flowing out from the valve. Fit the injection pump as per the previous section with the exception of item 1 which is changed to item 1 be- l ow. 1. Place a shim 0.5 mm (.0196 in) in thickness under the injection pump flange. Fig. 88. Fitting of shim Fig. 90. Marking the pulley and engine block 1. Shim 2. Remove the front pressure valve holder from the i njection pump. 5. Continue turning the crankshaft slowly clockwise until the fuel stops flowing out from the pressure valve holder.

Check the position of the crankshaft to the marking on the pulley and engine block at this point. See Fig. 90. If the position is after "Y°" (B.T.D.C.) a thinner shims should be used under the injection pump flange. If the position exceeds "Z°" (B.T.D.C.) a thicker shims should be fitted instead. (See table below). 1. Pressure valve holder 4. O-ring 2. Spring 5. Copperwasher 3. Pressure valve 6. Pump element Fig. 89. 3. Remove the pressure valve and replace the pres- sure valve holder. 4. Move the throttle arm to max. position. Turn the crankshaft clockwise until the piston in cylinder No.

1 moves upwards in the compression stoke and fuel begins to flow out from the pressure valve (po- sition X in the table below). The work is simplified if an approx. 50 mm (2 in) "observation tube" is fitted on the pressure valve. engine number - product number 55 Engine model Pos. of crankshaft in ° X Y Z Injection start, crankshaft pos. MD2010 30,0 24,5 26,5 24,5-26,5° f.o.d. M D2020 up to 5101311299 from 5101311300 30,0 30,0 24,5 26,0 26,5 28,0 24,5-26,5° B.T.D.C. 26,0-28,0° B.T.D.C. M D2030 up to 510101938 from * 510101939 30,0 30,0 21,5 20,5 23,5 22,5 21,5-23,5° B.T.D.C. 20,5-22,5° B.T.D.C. M D2040A MD2040B **868748 30,0 20,0 22,0 20,0-22,0° B.T.D.C.

MD2040B **868778 MD2040C 30,0 18,0 20,0 18,0-20,0° B.T.D.C.