Fuel system I njectors 7. Fit the fuel leak pipe. Replacement of injectors 8. Fit the delivery pipes. Check that they do not come skew, and tighten the nuts. 2. Release the delivery pipes at the injection pump and at the injectors. Lift off the delivery pipes to- gether. 1. Wash clean round the injectors. Tightening torque: 20-25 Nm (14.7-18.4 ft.lbs). 3. Remove the nut on the top of each injector and lift off the fuel leak pipe. 9. Start the engine and check that no leakage occurs. Renovating injectors 1. Clean the injector internally. 2. Place the injector (holder) in a vice. Unscrew the nozzle nut and take the injector apart. Note:
Observe care when taking it apart so that the nozzle needle does not drop out. 3. Pull out the nozzle needle from the nozzle sleeve and place the parts in cleaning petrol. Note: Make sure that the nozzle needles and nozzle sleeves which belong together and are adjusted to each other are not mixed up if several nozzles are cleaned together. To avoid confusion the nozzles . should be placed in a nozzle rack or in different compartments. 4. Fig.102. Dismantling of injector Check the nozzle carefully with a lamp magnifier or 1. Injector 3. Heat shield (MD2030) 5. 2. Copper packing 4. Insert (MD2O10-2030) i n a microscope. Check the other parts also.
When fitting a new nozzle it is important that pre- serving oil is washed off the nozzle needle and sleeve before the injector is assembled (avoid skin contact with needle's slide surface). Clean the parts in pure alcohol. Check that the nozzle needle slides in the sleeve without sticking. 4. Unscrew the injectors. Use socket, L = 80 mm. 6. Socket width = 22 mm (MD2O10, 2020, 2040), socket width = 27 mm (MD2030) Dip the nozzle parts in pure diesel or testing oil and put the injector together. Use the original thickness of adjuster washer(s) to set the opening pressure. Remove the copper packings under the injectors. 7. MD2030: Remove the heat shields (3, Fig. 102).
Check the opening pressure, jet pattern and tight- ness in a nozzle testing device. MD2O10, MD2020, MD2030: Remove the inserts (4) and the inner copper washers. 5. Fit a protective cap on the pipe connections on the i njectors over the nozzle if the injector is not to be fitted immediately. 6. Fit the new injector. Tightening torque: see Technical data. 60