volvo — page 55

Fuel system Setting engine speed (RPM) Check that the throttle mechanism functions normally. Check that the throttle arm (1) (Fig. moves towards low 2. Warm up the engine and check the idling speed using a workshop tachometer (see Technical Data for correct idling speed). i dle (2) when the throttle mechanism is in idling position and moves towards the stop screw at wide open throttle 3. I f necessary, adjust to the correct idling speed using the adjustment screw (2). ( WOT) (3) when the throttle mechanism is at wide open throttle (WOT). Adjust the throttle mechanism if neces- sary. Also check that the air filter and air intake are not blocked. 4. Check gap (3) again according to point 1.

I MPORTANT! The engine speed (RPM) and fuel quantity are factory set to give maximum output and minimum environmental impact. The- se settings must not be changed Engine racing (high idling speed) Warm up the engine and check the engine racing speed using a workshop tachometer when the engine has no Seals on the fuel injection pump may only be broken by authorised personnel. Broken seals must always be resealed l oad at wide open throttle (WOT) (see Technical Data for correct engine racing speed). Adjust if necessary as follows: 1. Slacken off the stop screw (3) so that it does not li- mit the movement of the throttle arm (1). 2.

Run the engine with no load at wide open throttle ( WOT) and adjust to the correct rev speed using the adjustment screw (4) (remember to reseal the screw). 3. Adjust the stop screw (3) so that there is a clearan- ce of 0.1 mm between the stop screw (3) and the throttle arm (1) when the throttle mechanism is at wide open throttle (WOT). Feed pump Fig. 92. Setting engine speed (RPM) Dismantling of feed pump 1. Throttle arm 1. Wash clean round the pump. 2. Adjustment screw, low idling speed 3. Stop screw, wide open throttle (WOT) 4. Adjustment screw, engine racing 5. Adjustment screw, maximum quantity of fuel 2. Close the fuel cocks. Release the fuel connections from the pump.

Dismantle the feed pump from the cylinder block. Low idle speed Empty the pump of fuel. 3. 1. Check that gap (6) (Fig. 92) is approximately 3 mm when the throttle mechanism is in the idling posi- tion. If necessary: Slacken off the locknut (7) and adjust until the correct gap is obtained with the screw (8). 5 7