Cooling system Repair instructions NOTE! Close the bottom valve before working on the cooling system. Refrigerant The refrigerant has the twin purpose of protecting the cooling system from freezing and preventing corrosion. Antifreeze Use a mixture of 50 % Volvo Penta antifreeze (glycol) and 50 % pure water (as neutral as possible). This mixture prevents freezing down to approx. -40°C (-40°F) and should be used all year round. Note: At least 40 % antifreeze should be used in the sys- tem to ensure satisfactory corrosion protection. Mix the antifreeze with water in a separate vessel before filling the cooling system. Fig. 105.
Draining of the refrigerant For replenishment of the refrigerant see the instruction on page 64. The sea water system Watch out for the penetration of water in the boat! Close the bottom cock or the cock on the S- drive. Release the cover on the sea water pump and let the water run out. 0 WARNING! Antifreeze is hazardous to health 1. (dangerous to consume). I n the event that antifreeze is not necessary it is appropri- ate to add Volvo Penta anti-corrosion agent 1141526-2. 2. Release the hose from the sea water pump and sea water filter at the reverse gear and tilt down so that the water runs out. 3. Draining of the refrigerant Stop the engine before draining the cooling system.
Check if there are additional cocks/plugs at low points on the refrigerant and exhaust pipes. Check carefully that all the water runs out. The fresh water system 4. Tighten the hoses and cover to the sea water pump. Pump out the boat and check that there is no 1. Unscrew the filler cap. Turn the cap to the first stop and wait a moment before lifting off the cap. WARNING! Open the filler cap very carefully if the engine is hot. Steam or hot liquid may spit out. l eakage. 0 2. Connect a hose to the drain cock. Open the cock and drain out the refrigerant in a vessel. Hand in the mixture to a recovery station if it is not to be used again. Never pollute the water. 6 3