Cooling system Replenishment of refrigerant v ft Flush the cooling system before filling up with re- frigerant. Close all the drain points and fill up with refrigerant to the correct level. See next page. Filling should be done with an idle engine. The en- gine must not be started before the system is vented and completely filled. If a heater unit is connected to the engine's cooling system the heat control valve must be fully opened and the unit vented during filling. l I N Note: Fill the system slowly! Filling should not be done too quickly or else air pockets can form in the sys- tem. The air should be allowed to flow out through the filling opening.
Check the engine coolant level after run- ning the engine for some time. Top up coolant if re- quired. Check hoses and connections and seal any leaks. MD 2010-2040C Refrigerant level Refrigerant temperature too low Check the engine coolant level 0 WARNING! Do not open the engine coolant system filler cap when the engine is still hot ex- cept in an emergency Steam or hot coolant may spray out. If the refrigerant temperature is too low this may be be- cause of: - Defective thermostat. - Defective temperature sensor or instrument. Refrigerant temperature too high Turn the filler cap to the first stop and let any pressure escape from the system before removing the cap.
Top up coolant if necessary. For MD2O10-204OA/B the level must be just under the neck of the filler opening and for MD2O10-2040C between the lower edge of the neck of the filler opening and the level spur (1). Reinstall the fill- er cap. If the refrigerant temperature is too high this may be be- cause of: Blocked sea water inlet or sea water filter. Defective pump wheel in the sea water pump. Too low refrigerant level, air in the fresh water sys- tem. Slipping or burst belt for the circulation pump. If a separate expansion tank is installed (optional extra) the level should be between the MAX and MIN marks. Defective thermostat, temperature sensor or instru- ment. Blocked cooling system.
I ncorrectly set injection pump, i.e. injection angle. Refrigerant loss There are two types of refrigerant loss: - Refrigerant loss when running. - Refrigerant after stopping with a hot engine. Refrigerant loss when running may be because the cooling system is not tight or because air or combustion gases have been forced into the system. MD 2010-2040A/B Refrigerant level 64