Cooling system Replacing the circulation pump Dismantling 1. Drain off the refrigerant from the engine (fresh wa- ter system). 2. Release the alternator and remove the drive belt. MD2030, MD2040: Remove the clamp for the alter- nator. 3. Remove the rubber hoses to and from the pump. Fig. 108. Application of sealing compound (silicon) 4. Release the electric cables to the temperature re- l ay. 3. Apply sealing compound (silicon, Volvo Penta part No. 1161277-7) on the cylinder block as per Fig. 108, shaded area. Fit the refrigerant pump with a new gasket. 4. MD2030, MD2040: Fit the clamp to the alternator. 5. Fit the rubber hoses at the pump's inlet and outlet. Tighten the hose clips. 6.
Fit the drive belt. It should be possible to press the belt down approx. 10 mm (.40 in) between the pul- Fig. 107. MD2030. Circulation pump l eys. 5. Remove the pump's attachment screws and lift off the pump. 7. Connect the contact piece to the temperature relay. 8. Fill up with refrigerant. Start the engine and check that no leakage occurs. MD2030: Remove the back piece (plate), spring, and thermostat. Fitting Replacing the pump wheel in the sea water pump 1. Clean the mating surfaces on the pump and cylin- der block. Close the bottom cock, or the cock on the S-drive before working on the cooling system. 2. MD2030: Place the thermostat and spring in the pump.
Fit the back piece (plate) on the pump with a new gasket. 1. Dismantle the pump's end cover and drain off the water in the sea water system. 66