Cooling system 1 M D2040 MD2O10-2020 Fig. 109. Replacing the pump wheel 2. Pull and twist out the pump wheel (impeller) with a pair of universal pliers. M D2030 Fig.110. Positioning of the thermostat 3. Clean the housing internally. Grease in the pump housing and inside of the cover with a little grease. 1. Cover 4. Press in the new wheel with a rotational motion 3. (clockwise). Fit the sealing washer on the outer end of the centre of the wheel. MD2O10, MD2020: Release the exhaust pipe and remove the heat exchanger housing complete. Re- move the spring and lift out the thermostat from the housing. 5. Fit the cover together with a new gasket. 4. MD2040:
Remove the cover (1) on the front left- hand side of the heat exchanger. Remove the rub- ber ring. 6. Open the bottom cock, or the cock on the S-drive. Start the engine and check that no leakage occurs. Checking the thermostat Thermostat 1. Check that the thermostat closes completely. Replacing the thermostat 2. Heat up water in a vessel to 68°C 1 154.4°F ( MD2O10, MD2020), or to 75°C / 167°F (MD2030, MD2040). Note: On MD2030 the thermostat is accessible after the circulation pump has been removed. See under head- 3. Submerge the thermostat in the water. Check after at least 3-5 minutes that the thermostat is still closed. i ng "Replacing the circulation pump" on page 66. Other engines: 4.
Raise the temperature to boiling point (100°C / 212°F). Check after 3-5 minutes that the thermo- stat has opened at least 6 mm /.02362 in 1. Remove both battery leads. Drain off the water in the fresh water system. ( MD2O10, MD2020), or to 8 mm /.3149 in ( MD2030, MD2040). 2. MD2O10, MD2020: Drain off the water in the sea water system. Remove the alternator. Replace the thermostat if these specifications are not met. NOTE! If the thermostat does not close completely the engine will run at too low a temperature. 67