Electrical system Galvanic corrosion Electric welding MD201OB/C, MD2020B/C, MD203OB/C, MD204OB/C Remove the plus and minus leads from the batteries, and then remove all cables to the alternator. The engine's flywheel housing and transmission (re- verse gear/S-drive) are electrically insulated from the engine. Note the fitting sequence on the screw union (Fig. 113). The insulation sleeve pos. 1 is only fitted on one of the screws (optional screw). Q WARNING! The flywheel housing or transmission (reverse gear alt. S-drive) must under no circum- stances be earthed. Earthing of these compo- nents can result in serious damage as a result of galvanic corrosion.
Always connect the welding clip to the component which is to be welded and as close to the weld point as possible. The clip must never be connected to the en- gine or so that the current can pass over a bearing. 0 On completion of welding: Always connect the cables to the alternator before the battery leads are replaced. Starting with auxiliary battery 0 WARNING! The batteries (especially the auxiliary battery) contain oxyhydrogen gas which is very explosive. A spark, which can occur if the auxili- ary battery is incorrectly connected, is sufficient to cause the battery to explode and result in injury. Repair instructions ,u -umfi ~ i J - Note:
If the start battery has frozen it must be thawed first before a start attempt is made with the auxiliary battery. Check that the battery is not damaged before connecting it again. 1. Check that the auxiliary battery's rated voltage cor- responds to the engine's system voltage (12V). 2. Connect the red auxiliary lead (+) to the auxiliary battery and then to the flat battery. Then connect the black auxiliary lead (-) to the auxiliary battery, and finally to a point some distance from the flat batteries, e.g.
at the main switch on the minus lead or at the minus lead's connection on the starter mo- tor (2-pole electrical system), or at the minus lead's connection on the engine (one-pole system). 3. Start the engine. NOTE! Do not touch the con- nection during the attempt to start (risk for sparks) and do not lean over any of the bat- teries. i ng and transmission Fig. 113. Electrical insulation (A) of the flywheel hous- 4. Remove the leads in exactly the reverse order to the way they were connected. NOTE! The ordin- ary leads to the standard battery must absolute- 1. Insulation sleeve 2. Insulation washer 3. Washer l y not be disconnected. 7 1