Electrical system Procedure A WARNING! Disconnect the current and remove both battery leads before working on the charging circuit. Checking the battery leads Set the multimeter for voltage testing and then connect the multimeter between the battery's plus and minus pole. Run the engine at approx. 2000 rpm. Read off and note the voltage over the battery poles. If the voltage drop during any of the tests as per the The alternator provides approx. 14.0 V: Conduct test as follows: i tems above exceeds 0.2 V the lead connections must be removed and cleaned from oxide etc. Spray the con- nections with a moisture repellant contact oil (Volvo Universal oil, part. No.
1161398-1) or the like and tight- en the connection again. Connect the multimeter between the alternator's B+ and B- connections. Run the engine at approx. 2000 rpm. The alternator should provide 14.0-14.4 V. The total voltage drop must not exceed 0.4 V. Rectify the connections at the battery, main switch, starter motor, alternator, glow relay and glow plug. Voltage drop less than 0.2 V: Alternator Battery leads in good condition. Voltage drop more than 0.3 V: Checking and troubleshooting of the al- ternator Conduct check of battery leads. Dismantle the alternator's electrical connections. The alternator provides more than 14.4 V: Spanner widths 8 and 10 mm.
See items "Checking and troubleshooting of alternator" and "Checking of the regulator". Remove the alternator belt. Dismantle the alternator. Spanner widths 1 1/16"; 5/8"; 12 mm and 13 mm. Release the voltage regulator's connections at the alter- nator's B+ connection. Remove the flat pin at connec- tion B+ and D+. Remove the cap on the W connection. Bend the plastic guard's attachment lugs alternately off the alternator. Release the regulator's two connection cables to the diode bridge. Use long-nose pliers or poke out the cable lugs with a screwdriver. Do not pull the cables!
Checking of positive battery lead Connect the multimeter between the alternator's B+ connection and the battery's plus pole. Run the engine at approx. 2000 rpm. The voltage drop must not exceed 0.2 V. If the voltage drop exceeds this value the lead connections must be rectified as per the "Procedure" below. Replacement of carbon brushes in the alternator After this carry out a test as per "Checking of negative battery charging". Unscrew the voltage regulator. Unscrew the brush hold- er. Check the length of the carbon brushes. Replace the brushes if they are 5 mm (.1968 in) or shorter. Carbon and holder are replaced as one unit.
Unsolder the con- nection cables and solder on the new ones with an acid-free soft solder. Checking of negative battery lead Connect the multimeter between the alternator's B- connection and the battery's minus pole (-). Run the engine at approx. 2000 rpm. The voltage drop must not exceed 0.2 V. If the voltage drop exceeds this value the lead connections must be rectified as per the "Procedure" below. 74