. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE Open drain valves (6) and (7), and drain the coolant. temperature rises above 90 ° C (194 ° F), run the engine for about 10 minutes. 8. Stop the engine and open drain valves (6), (7) to drain the water. 10. Close drain valves (6), (7). 4 - 22 6. Set containers to catch alve and drain valve (7) on the engine site. 7. After draining the antifre eze solution, close drain valve (6) , (7), . After the radiator is filled with w ater, ater 9. After draining the water, clean the radiator with detergent , follow the instruction of deterge 11. Install the covers (4) an d (5). gh the water filler up to the bottom of the filler port.
coolant density, see the COOLANT DENSITY TABLE. 12. Add Supercoolant throu gh the water filler up to the botto m of For details of the Super coolant density, see the COOLA 13. Run the engine at low id ling for 5 minutes to remove the a ir from the water, then run at high idling for 5 minutes ( Leave radiator cap (3) removed when doing this. ) on cover (8), drain the coolant from nside of the sub-tank, then add water d LOW marks. emely dirty and it is difficult to clean, part. approx. 3 minutes, add Supercoolant iller port, then tighten the radiator cap 14.
Open sub-tank inspecti from sub-tank (9), wash the i to between the FULL an If the sub-tank is extr replace it with a new nside of the sub-tank, then add w ater 15. Stop the engine, wait for approx. 3 minutes, add Supercoolant up to the bottom of the f (3). 16. Install cover (2).