Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE CAUTION 4. Start the engine. from the air bleeder (3). 4 - 36 BLEEDING AIR FROM HYDRAULIC SYSTE For details of the pro cedure when starting the eng ine, see "STARTIN G ENGINE (PAGE 3- 98)". I f necessary , refer to the OPERATION volume for the sections for sta rting the engine, m oving th e machine off, steering, and stopping. When starting the engi ne to bleed the air, cancel the aut omatic warming-up o peration before starting. Method of canceling automatic warming-up operatio 1. Turn the starting 2. Hold the fuel cont rol dial at the MAX position for 3 3. Turn the fuel cont NOTICE ws.

ment, swing) (Bleed the air without starting the engine) circuit e pump with the engine stopped. e speed of 1000 rpm or below and operate the cylinders slowly. operation suddenly, or raise the cylinder pressure, or operate the cylinder to the end of its stroke. cylinder for the first stroke (extending and retracting), operate particularly slowly. Bleed the air as follo 1. Pump (work equip ment, swing) (Bleed the air witho ut starting the engin 2.

Work equipment Bleed the air from th e pump with the engine stopped Run the engine at th e speed of 1000 rpm or below an d operate the cylinde rs slowly Do not carry out the operation suddenly, or raise the cylinder pressure, or operate the cylinder to t he end of its stroke When operating the cylinder for the first stroke (exte nding and retracting) , operate particularly slo When operating the cylinder for the first stroke, there is a large amount of air inside the circuit, so th e work equipment will not move for at least 10 seconds. Be careful not to opera te the lever to the en d of the s troke. Use clean oil of NAS 7 class or above when filling the pump.

Be sur e to us e a clean oil can. Bleed the air from th e various components in the order below ( 1.-6.). 1. Bleeding air from pump (Do this before startin g the engine oil (4) oozes