Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 2) If no oil oozes out, remove the drain hose from the pump so (1) and install the drain hose. oil, the pump. 4 - 37 dd hydraulic oil thro ugh drain port (2) . me out when the drain hose is rem hose mouthpiece at oil in the hydraulic t a position higher ank. 3) After compl eting the air bleed op eration, tighten a NOTICE If the drain hose is in stalled first, oil will spu rt out from air blee If the pump is operat ed without filling the p ump case with hyd abnormal heat will be generated and this ma y cause premature 2.

Starting engine Cancel the auto matic warming-up o peration, start the engine, and run it at low idling for 10 minutes after starting. After that, do a s follows. 3. Bleeding air fro m cylinders 1) Run the en not moved 2) Next, oper 3) Finally, ope 1) Run the en gine at low idle, and extend and retra ct each cylinder 4 to 5 times, taking care that a cylinder is to the end of its stro ke. (Stop the cylin der approx. 100 mm (3.9 in) short of its stroke end) ove the air. 2) Next, oper ate each cylinder 3 to 4 times to the e nd of its stroke.

3) Finally, ope rate each cylinder 4 to 5 times to the end of its stroke to completely rem NOTICE If the engine is run at high speed immediately after startup or a c ylinder is pushed up to its stroke end, air taken inside the cylinder may cause damage t