. MAINTENANCE MAINTENANCE PROCEDURE Rear swing motor bled from the swing motor, the motor bearings may be Front swing motor 5. Bleeding air from attachment (when installed) If an attachment has been installed, run the engine at low idling and operate the attachment pedal repeatedly (approx. 10 times) until the air has been bled from the attachment and circuit. NOTICE If the method of bleeding the air from the attachment itself is specified by the manufacturer, bleed the air according to the specified procedure. After completing the air bleeding operation, stop the engine, and leave the machine for 5 minutes before starting operations.
This will remove the air bubbles in the oil inside the hydraulic cylinders. Check that there is no leakage of oil and wipe off any oil that has been spilled. 4 - 38 4.
Bleeding air f rom swi ng moto r (bleed th e air on ly whe n the oil inside the swing motor case has been drained) 1) Run t he e ngine at low idling, r emove hose ( 1) at po rt S, and chec k tha t oil ooz es out f rom port S hose ( NOTIC Do not operate the swing un der any circumstan 2) If does sto engine, remov hose (1), and fill t he insid e of the mo tor cas e with h ydraulic oil 3) After completely bleeding the air, ti ghten p ort S h ose (1 4) Run the engine at low i dle, and s lowly s wing th e upper structure at least 2 times uniformly to the le ft and NOTIC E ir is If t he a ir is no damaged.