Kubota — Replacing Hydraulic Oil Filter

PERIODIC SERVICE 80 (1) Fuel filter (1) Hydraulic oil filter (2) Magnetic filter (Wipe off metal filings) B Replacing Hydraulic Oil Filter C Cleaning Magnetic Filter 5. Put a film of clean transmission oil on the rubber seal of the new filters. 6. Tighten the filter quickly until it contacts the mounting surface. Tighten filter by hand an additional 1/2 turn only. 7. After the new filters have been replaced, fill the transmission oil up to the upper notch on the dipstick. To avoid personal injury or death: A Be sure to stop the engine before changing the oil filter cartridge. A Allow engine to cool down sufficiently, oil can be hot and can burn. 1.

Remove the drain plug at the bottom of the transmission case and drain the oil completely into an oil pan. 2. After draining reinstall the drain plug. (1) Gauge (A) Oil level is acceptable within this range. 8. After running the engine for a few minutes, stop the engine and check the oil level again, add oil to the prescribed level. 9. Make sure that the transmission fluid doesn't leak pass the seal on the filters. (1) Drain plug A To prevent serious damage to the hydraulic system, use only a KUBOTA genuine filter. A Do not operate the tractor immediately after changing the transmission fluid. Run the engine at medium speed for a few minutes to prevent damage to the transmission. 3.

Remove the 2 oil filters. 4. Wipe off metal filings from the magnetic filter with a clean rag.