Kubota — Replacing Fuel Filter

79 PERIODIC SERVICE EVERY 500 HOURS B Replacing Engine Oil Filter B Changing Engine Oil To avoid personal injury or death: A Be sure to stop the engine before replacing the oil filter cartridge. A Allow engine to cool down sufficiently, oil can be hot and can burn. To avoid personal injury or death: A Be sure to stop the engine before changing the oil. A Allow engine to cool down sufficiently, oil can be hot and can burn. 1. Remove the oil filter. 2. Put a film of clean engine oil on the rubber seal of the new filter. 3. Tighten the filter quickly until it contacts the mounting surface. Tighten filter by hand an additional 1/2 turn only. 4.

After the new filter has been replaced, the engine oil normally decreases a little. Make sure that the engine oil does not leak through the seal and be sure to check the oil level on the dipstick. Then, replenish the engine oil up to the prescribed level. 1. To drain the used oil, remove the drain plug at the bottom of the engine and drain the oil completely into the oil pan. All the used oil can be drained out easily when the engine is still warm. 2. After draining reinstall the drain plug. 3. Fill with the new oil up to the upper notch on the dipstick.

(See "LUBRICANTS" in "MAINTENANCE" section.) (1) Engine oil filter (1) Oil inlet (2) Dipstick (A) Oil level is acceptable within this range A To prevent serious damage to the engine, use only a KUBOTA genuine filter. B Replacing Fuel Filter 1. Remove the fuel filter. 2. Put a film of clean fuel on rubber seal of new filter. 3. Tighten the filter quickly until it contacts the mounting surface. Tighten filter by hand an additional 1/2 turn only. 4. Bleed the fuel system. (See "Bleeding Fuel System" in "SERVICE AS REQUIRED" in "PERIODIC SERVICE" section.) (1) Drain plug Oil capacity with filter 10.7 L