PERIODIC SERVICE 78 B Adjusting Air-Conditioner Belt Tension EVERY 400 HOURS B Cleaning Water Separator This job should not be done in the field, but in a clean place. 1. Close the fuel cock. 2. Unscrew the retainer ring and remove the cup, and rinse the inside with kerosene. 3. Take out the element and dip it in the kerosene to rinse. 4. After cleaning, reassemble the water separator, keeping out dust and dirt. 5. Bleed the fuel system. (See "Bleeding Fuel System" in "SERVICE AS REQUIRED" in "PERIODIC SERVICE" section.) To avoid personal injury or death: A Be sure to stop the engine before checking belt tension. 1. Stop the engine and remove the key. 2.
Apply moderate thumb pressure to belt between pulleys. 3. If tension is incorrect, loosen the tension pulley mounting nut and turn the adjusting bolt to adjust the belt tension within acceptable limits. 4. Replace air-conditioner belt if it is damaged. (1) Fuel cock (2) Retainer ring (3) Cup (A) "CLOSE" (1) Adjusting bolt (2) Tension pulley mounting nut (A) Check the belt tension (1) O ring (2) Element (3) Spring (4) Red float (5) Cup (6) Retainer ring Proper air- conditioner belt tension A deflection of between 10 to 12 mm when the belt is pressed (98 N [10 kgf]) in the middle of the span.