83 PERIODIC SERVICE EVERY 1000 HOURS A Do not operate the tractor immediately after changing the transmission fluid. Run the engine at medium speed for a few minutes to prevent damage to the transmission. B Changing Transmission Fluid To avoid personal injury or death: A Allow engine to cool down sufficiently, oil can be hot and can burn. B Changing Front Axle Gear Case Oil & Front Differential Case Oil 1. To drain the used oil, remove the drain plugs at the both front axle gear cases and filling plugs, and drain the oil completely into the oil pan. 2. After draining reinstall the drain plugs. 3.
Fill with the new oil of the specified amount from both filling ports on the front axle gear case, and filling port on the front differential case. (See "LUBRICANTS" in "MAINTENANCE" section.) 4. After filling reinstall the filling plugs. 1. To drain the used oil, remove the drain plug at the bottom of the transmission case and drain the oil completely into the oil pan. 2. After draining reinstall the drain plug. 3. Fill with the new KUBOTA SUPER UDT fluid up to the upper notch on the dipstick. (See "LUBRICANTS" in "MAINTENANCE" section.) 4. After running the engine for a few minutes, stop it and check the oil level again; add oil to prescribed level.
A Fill up specified amount certainly although it takes time to pour the oil. (1) Drain plug (1) Dipstick (2) Oil filling plug (A) Oil level is acceptable within this range Oil capacity ront Axle Gear Case 3.0 L for each side ront Differential Case 5.0 L Oil capacity 52 L