Kubota — Flushing Cooling System and Changing Coolant

PERIODIC SERVICE 84 EVERY 2000 HOURS or 2 YEARS Be sure to do the following servicing once every 2000 hours or biennially, whichever comes first. B Flushing Cooling System and Changing Coolant To avoid personal injury or death: A Do not remove radiator cap while coolant is hot. When cool, slowly rotate cap to the first stop and allow sufficient time for excess pressure to escape before removing the cap completely. (1) Drain plug (2) Filling plug A Do not remove the bolt(A). 1. Stop the engine, remove the key and let it cool down. 2. To drain the coolant, open the radiator drain plug, remove the drain plug and remove radiator cap.

The radiator cap must be removed to completely drain the coolant. 3. After all coolant is drained, reinstall the drain plug. 4. Fill with clean soft water and cooling system cleaner. 5. Follow directions of the cleaner instruction. 6. After flushing, fill with clean soft water and anti-freeze until the coolant level is just below the radiator cap. Install the radiator cap securely. 7. Fill with coolant up to the "FULL" mark of recovery tank. 8. Start and operate the engine for few minutes. 9. Stop the engine, remove the key and let cool. 10.Check coolant level of recovery tank and add coolant if necessary. 11.Properly dispose of used coolant.

(1) Bolt(A) B Adjusting Engine Valve Clearance Consult your local KUBOTA Dealer for this service. EVERY 1000 HOURS or 1 YEAR Be sure to do the following servicing once every 1000 hours or yearly, whichever comes first. B Replacing Air Cleaner Primary Element and Secondary Element (See "Cleaning Air Cleaner Primary Element" in "EVERY 100 HOURS" in "PERIODIC SERVICE" section.) EVERY 1500 HOURS B Checking Fuel Injection Nozzle (Injection Pressure) Consult your local KUBOTA Dealer for this service. (1) Drain plug Coolant capacity 9 L