85 PERIODIC SERVICE B Anti-Freeze To avoid personal injury or death: A When using antifreeze, put on some protection such as rubber gloves (Antifreeze contains poison.). A If it is swallowed, seek immediate medical help. Do NOT make a person throw up unless told to do so by poison control or a health care professional. Use standard first aid and CPR for signs of shock or cardiac arrest. Call your local Poison Control Center or your local emergency number for further assistance. A When antifreeze comes in contact with the skin or clothing, wash it off immediately. A Do not mix different types of Antifreeze. The mixture can produce chemical reaction causing harmful substances.
A Antifreeze is extremely flammable and explosive under certain conditions. Keep fire and children away from antifreeze. A When draining fluids from the engine, place some container underneath the engine body. A Do not pour waste onto the ground, down a drain, or into any water source. A Also, observe the relevant environmental protection regulations when disposing of antifreeze. (1) Drain plug ((+) Plus screwdriver) Always use a 50/50 mix of long-life coolant and clean soft water in KUBOTA engines. Consult your local KUBOTA Dealer concerning coolant for extreme conditions. 1. Long-life coolant (hereafter LLC) comes in several types. Use ethylene glycol (EG) type for this engine. 2.
Before employing LLC-mixed cooling water, fill the radiator with fresh water and empty it again. Repeat this procedure 2 or 3 times to clean up the inside. 3. Mixing the LLC Premix 50% LLC with 50% clean soft water. When mixing, stir it up well, and then fill into the radiator. 4. The procedure for the mixing of water and antifreeze differs according to the make of the antifreeze and the ambient temperature. Refer to SAE J1034 standard, more specifically also to SAE J814c. (1) Radiator cap (2) Recovery tank A Do not start engine without coolant. A Use clean, fresh soft water and anti-freeze to fill the radiator and recovery tank.
A When mixing the anti-freeze with water, the anti-freeze mixing ratio is 50 %. A Securely tighten radiator cap. If the cap is loose or improperly fitted, water may leak out and the engine could overheat. A On cab type machines, coolant circulates through the heater. This means that one more liter or so of coolant is required. In changing coolant, pour coolant up to the filler port of the recovery tank. Turn ON the heater (shift the temperature control dial toward WARM), and run the engine for a while in order to warm coolant. Then stop the engine. When coolant has cooled down, some of the coolant in the recovery tank is sucked. Now the recovery tank is appropriately filled with coolant.
D At 1.013 x 10 Pa (760mmHg) pressure (atmospheric). A higher boiling point is obtained by using a radiator pressure cap which permits the development of pressure within the cooling system. Vol % Anti-freeze Freezing Point Boiling Point* 50 -37 108