Kubota — Adding Washer Liquid

PERIODIC SERVICE 90 B Replacing Head Lamp B Lubricating Points To avoid personal injury: A Be careful not to drop the bulb, hit anything against the lamp, apply excess force, and get the lamp scratched. If broken, glass may cause injury. Pay more attention to halogen lamps in particular, which have high pressure inside. A Before replacing the lamp, be sure to turn off the light and wait until the bulb cools down, otherwise, you may get burned. 1. While pushing the right and left lock buttons, pull and remove the electrical connector. 2. Remove the rubber boot. 3. Remove the clamping fixture and take out the bulb. 4.

Replace with a new bulb and reinstall the head lamp assembly in the reverse order. (1) Door hinge (2) Rear window hinge B Adding Washer Liquid 1. Remove the cover and open the washer liquid tank cap. 2. Add a proper amount of automobile washer liquid. (1) Electrical connector (2) Lock buttons (3) Rubber boot (4) Clamping fixture (5) Bulb (A)"Base's wider projection to face upward" (1) Cover (2) Knob bolt (3) Washer liquid tank cap A Be sure to use a new bulb of the specified wattage. A Never touch the bulb surface (glass) with bare hands. Fingerprints, for example, may break the bulb. Tank capacity 1.0 L