OPERATING THE TRACTOR 24 B Creep Speed Shift the range gear shift lever to to obtain low speeds. This shifting requires clutch operation. B 4WD / Bi-speed Turn Switch To avoid personal injury or death: A Do not engage the front wheel drive when traveling at road speed. A When driving on icy, wet, or loose surfaces, make sure the tractor is correctly ballasted to avoid skidding and loss of steering control. Operate at reduced speed and engage front wheel drive. A 4WD model tractor is equipped with 4 wheel braking and appropriate care should be taken during hard braking. A An accident may occur if the tractor is suddenly braked, such as by heavy towed loads shifting forward or loss of control.
A The braking characteristics are different between 2 and 4-wheel drive tractor models. Be aware of the difference and use carefully. A Do not use "Bi-speed Turn" at high speed. A "Bi-speed Turn" enables short and fast turns, therefore, become familiar with its performance before operating in close or confined areas. A Do not use the Bi-speed turn when operating the front end loader. (1) Range gear shift lever ... Creep ON C Creep speed should be used only when doing one of the following jobs: 1. Deep rotary-tilling and harrowing 2. Planting 3. Turf application C Creep speed can not be used for any of the followings: 1. Pulling a trailer 2. Front-loader operation 3. Front-blade operation 4.
Earth-moving 5. Entering and leaving a field 6. Loading onto and unloading from a truck When this switch is pressed; The front wheel drive (4WD) is engaged. The 4WD indicator comes on when the system is in 4WD mode. Press the switch again; The Bi-speed turn system activates. The indicator within the switch and 4WD indicator and Bi-speed turn indicator come on when the system is in Bi-speed turn mode. To avoid personal injury or death: A When you leave the tractor, be sure to apply the parking brake and stop the engine. A IN APPLYING THE BRAKES: Press the switch one more time; The drive system returns to 2WD mode. All the indicators go off when the system is in 2WD mode.
(While the brake pedal is stepped on or the parking brake is applied, however, the 4WD braking system is working and the 4WD indicator stays on.) A The torque of the wheel axle is extremely high while creep speed is being used. Be sure to step down on the clutch pedal completely before applying the brakes, or they will not work A When starting to operate the tractor, be sure to release the parking brakes. Misuse of the brakes may cause damage to the transmission and is therefore not acceptable to KUBOTA for coverage under the warranty. A Press the clutch pedal completely down and stop the tractor's motion before shifting the range gear shift lever.