39 3-POINT HITCH & DRAWBAR 3-POINT HITCH B Selecting the holes of Lower Links There are 2 holes in the lower links. For most operations the lifting rods should be attached to the (B) hole. 1 . Make preparations for attaching implement. B Category 1 & 2 The standard tractor has both category 1 & 2. Category 1 type is standard and assemble all parts shown as below. To change from category 1 to category 2. 1. Remove adjusting collar from the lower link. 2. Add side collar onto both the lower links. 3. Remove adjusting collar from the rear top link pin. 4. Use the correct rear top link pin for category 2.
(1) Lower link (2) Lifting rod (3) Split pin (4) Nut (5) Lift rod pin (6) Thrust collar holes: (A), (B) A The lifting rods may be attached to (A) for greater lifting force. A Install the thrust collar in the outside of the lower link. A Tighten the nut by hand and fix the nut with the cotter pin. B Selecting the Top Link Mounting Holes Select the proper set of holes by referring to the "Hydraulic Control Unit Use Reference Chart" in Hydraulic Unit section. If the hydraulic unit is set for draft control, draft response is more sensitive when an implement is connected to the lower set of top link mounting holes. If draft control is not required, it is recommended to use the top set (1).
(1) Lower link (2) Top link (3) Collar, lower link (1) (4) Top link rear pin (1) (5) Collar, top link (1) (6) Top link rear pin (2) (7) Collar, side (2)