41 3-POINT HITCH & DRAWBAR B Top Link 1. Adjust the angle of the implement to the desired position by shortening or lengthening the top link. 2. The proper length of the top link varies according to the type of implement being used. B Stabilizer Adjust the stabilizers to control horizontal sway of the implement. Turn the outer tube until one of its holes aligns with the inner tube hole. Insert the set-pin to lock the outer and inner tubes. When readjusting, make sure both the stabilizers are equal in overall length. (1) Top link (A) "Length of the screw" A The length of the screw at both ends of the top link must be the same always.
(1) Outer tube (2) Inner tube (3) Set-pin (4) Hole (1) Set-pin (2) Hairpin cotter