Kubota — Treads

TIRES B Treads To avoid personal injury or death: A Do not attempt to mount a tire on a rim. This should be done by a qualified person with the proper equipment. A Always maintain the correct tire pressure. Do not inflate tires above the recommended pressure shown in the operator's manual. A Front and rear treads can not be adjusted. A Always attach the wheels as shown in the factory- shipment state, otherwise tractor parts may be damaged. A When re-fitting or adjusting a wheel, tighten the bolts to the following torques then recheck after driving the tractor 200m (200 yards) and 10 times of shuttle movement by 5 m (5 yards), and thereafter according to service interval.

(See "MAINTENANCE" section.) A Do not use tires other than those approved by KUBOTA. A When optional different-diameter tires are fitted on the machine, the travel speed display mode must be changed. Otherwise the travel speed will not get correctly displayed. Such mode switching is also needed when the original tires are back on the machine. (See "PTO RPM / TRAVEL SPEED MONITOR" in "OPERATING THE TRACTOR" section.) B Inflation Pressure Though the tire pressure is factory-set to the prescribed level, it naturally drops slowly in the course of time. Thus, check it everyday and inflate as necessary.

N-m (kgf-m) A Maintain the maximum pressure in front tires, if using a front loader or when equipped with a full load of front weights. B Dual Tires Dual tires are not approved. TIRES, WHEELS AND BALLAST 47 TIRES, WHEELS AND BALLAST (1) (2) 260 to 304 (26.5 to 31.0) 244 (24.9) Front Rear 280 / 70R18 420 / 70R24 380 / 70R28 1150 mm 1066 mm 1046 mm Tire sizes Inflation Pressure Front 280 / 70R18 196 kPa (2.0 kgf/cm ) Rear 420 / 70R24 120 kPa (1.2 kgf/cm ) 380 / 70R28 120 kPa (1.2 kgf/cm )