Kubota — Air Control Vent

53 CAB OPERATION A When heating, do not keep the lever at the "RECIRCULATION" position for a long time. The windshield easily gets foggy. A While working in a dusty conditions, keep the lever at the "FRESH AIR" position. This increases the pressure in the CAB, which helps prevent dust from coming into the CAB. To avoid personal injury; A Replace the water hoses every 4 years. A Daily inspection Have the tractor repaired immediately if any of the following defects are discovered. (Such defects may cause burns or injury. They may also cause engine seizure or other serious failure.) A Scratches, cracks or swelling in water hoses. A Water leakage at water hose joints.

A Missing or damaged water hose protective wrap or grommets. A Loose mounting bolts, damaged brackets. A Do not touch the water hoses and the heater with your hand. You may get burned. A If the window fails to defrost in extreme conditions or becomes cloudy when dehumidifying the CAB, wipe off moisture with a soft cloth. A Do not block all the air outlets of the air conditioner. A problem could occur. B Control Panel C Recirculation / fresh air selection lever FRESH AIR: Set the lever to the position, and fresh air will flow into the CAB. This is helpful when you work in dusty conditions or if the glass windows get foggy.

(1) Mode switch (2) Temperature control dial (3) Blower switch (4) Air conditioner switch with indicator light (A) "WARM" (B) "COOL" RECIRCULATION: Set the lever to the position, and the in-CAB air will be recirculated. This is useful for cooling or heating the CAB quickly or keeping it extra cool or warm. C Mode Switch Set the mode switch to the desired position. Air is blown from the front and side air outlets. Air is blown from only the front air outlets. With this switch at the middle position, air is blown weaker from the side air outlets (head) and stronger from the front air outlets.

C Temperature Control Dial Set this dial at the desired position to obtain the optimum air temperature. Turn the dial in the "WARM" direction to obtain warmer air. Turn it in the "COOL" direction to obtain cooler air. C Blower Switch Air volume can be changed in 3 steps. At the "3" position, the largest air volume is obtained. C Air Conditioner Switch Push this switch to activate the air conditioner. An indicator light will light up when the switch is set to "ON". Push the switch again to turn the air conditioner off, in which case the indicator light will be off. (1) Recirculation / fresh air selection lever "FRESH AIR" "RECIRCULATION"