Kubota — Checking Engine Oil Level

PERIODIC SERVICE 64 B Checking and Refueling To avoid personal injury or death: A Do not smoke while refueling. A Be sure to stop the engine before refueling. 1. Check the amount of fuel by fuel gauge. 2. When the fuel warning indicator lights up, it is time to add fuel. (1) Red float (2) Fuel cock (3) Retainer ring (4) Cup (A) "WHITE LINE" A If water is drawn through to the fuel pump, extensive damage will occur. B Checking Engine Oil Level (1) Fuel tank cap To avoid personal injury or death: A Be sure to stop the engine before checking the oil level. 1. Park the machine on a flat surface. 2. Check engine oil before starting the engine or 5 minutes or more after the engine has stopped. 3.

To check the oil level, draw out the dipstick, wipe it clean, replace it, and draw it out again. Check to see that the oil level lines between the 2 notches. If the level is too low, add new oil to the prescribed level at the oil inlet. (See "LUBRICANTS" in "MAINTENANCE" section.) A Do not permit dirt or trash to get into the fuel system. A Be careful not to let the fuel tank become empty, otherwise air will enter the fuel system, necessitating bleeding before next engine start. A Be careful not to spill during refueling. If a spill should occur, wipe it off at once, or it may cause a fire.

A To prevent condensation (water) accumulation in the fuel tank, fill the tank before parking overnight. B Checking Water Separator 1. As water is collected in the water separator, the red float is raised. 2. When the red float has reached the white line, close the fuel cock, loosen the retainer ring, take out the cup, and clean the cup. Be careful not to break the element. 3. Place the cup back into position. Bleed the fuel system. (See "SERVICE AS REQUIRED" in "PERIODIC SERVICE" section.) (1) Oil inlet (2) Dipstick (A) Oil level is acceptable within this range. Fuel tank capacity 76 L