Kubota — Cleaning Evacuator Valve

65 PERIODIC SERVICE A When using an oil of different maker or viscosity from the previous one, remove all of the old oil. Never mix two different types of oil. A If oil level is low, do not run engine. 3. When the coolant level is lower than "LOW" mark of recovery tank, remove the radiator cap and check to see that the coolant level is just below the port. If level is low, add coolant. B Checking Transmission Fluid Level 1. Park the machine on a flat surface, lower the implement and shut off engine. 2. To check the oil level, draw out the dipstick, wipe it clean, replace it, and draw it out again. Check to see that the oil level lines between the 2 notches.

If the level is too low, add new oil to the prescribed level at the oil inlet. (See "LUBRICANTS" in "MAINTENANCE" section.) (1) Recovery tank (A) "FULL" (B) "LOW" A If the radiator cap has to be removed, follow the caution above and securely retighten the cap. A Use clean, fresh soft water and anti-freeze to fill the radiator. A If coolant should leak, consult your local KUBOTA Dealer. (1) Dipstick (2) Oil inlet (A) Oil level is acceptable within this range. B Cleaning Evacuator Valve Open the evacuator valve to get rid of large particles of dust and dirt. A If oil level is low, do not run engine. B Checking Coolant Level To avoid personal injury or death:

A Do not remove radiator cap while coolant is hot. When cool, slowly rotate cap to the first stop and allow sufficient time for excess pressure to escape before removing the cap completely. 1. Check to see that the coolant level is between the "FULL" and "LOW" marks of recovery tank. 2. When the coolant level drops due to evaporation, add soft water only up to the full level. In case of leakage, add anti-freeze and soft water in the specified mixing ratio up to the full level. (See "Flushing Cooling System and Changing Coolant" in "EVERY 2000 HOURS or 2 YEARS" in "PERIODIC SERVICE" section.) (1) Evacuator valve