Kubota — Adjusting Brake Pedal

71 PERIODIC SERVICE A The air cleaner uses a dry element, never apply oil. A Do not run the engine with filter element removed. A Be sure to refit the cover with the arrow (on the rear of cover) upright. If the cover is improperly fitted, evacuator valve will not function and dust will adhere to the element. A Do not touch the secondary element except in cases where replacing is required. (See "Replacing Air Cleaner Secondary Element" in "EVERY 1000 HOURS or 1 YEAR" in "PERIODIC SERVICE" section.) B Adjusting Brake Pedal To avoid personal injury or death: A Stop the engine and chock the wheels before checking brake pedal.

A To prevent uneven braking, the specification must be within the recommended limit. If found out of the specifications, contact your local KUBOTA Dealer for adjusting the brakes. C Evacuator Valve Open the evacuator valve once a week under ordinary conditions - or daily when used in a dusty place - to get rid of large particles of dust and dirt. C Checking the brake pedal free travel B Adjusting Alternator Belt Tension 1. Set the parking brake. 2. Slightly depress the brake pedals and measure free travel at the top of pedal stroke. To avoid personal injury or death: A Be sure to stop the engine before checking belt tension. 1. Stop the engine and remove the key. 2.

Apply moderate thumb pressure to belt between pulleys. 3. If tension is incorrect, loosen the alternator mounting bolts and, using a lever placed between the alternator and the engine block, pull the alternator out until the deflection of the belt falls within acceptable limits. 4. Replace alternator belt if it is damaged. (1) Brake pedals (A) "FREE TRAVEL" A Brake pedals should be equal when depressed. C Checking the brake pedal stroke 1. Disengage the brake pedal lock. 2. Depress the brake pedal several times. 3. Step on the right-hand pedal and measure the level difference (pedal stroke) between this pedal and the left-hand pedal.

(1) Bolt (A) Check the belt tension (B) To tighten Proper brake pedal free travel 7 to 14 mm on the pedal Keep the free travel in the right and left brake pedals equal. Proper alternator belt tension A deflection of between 10 to 12 mm when the belt is pressed in the middle of the span. Pedal stroke Less than 100 mm at each pedal