75 PERIODIC SERVICE C Adjusting procedures 1. Detach the snap ring. 2. Loosen the tie-rod nut. 3. Turn the tie-rod joint to adjust the rod length until the proper toe-in measurement is obtained. 4. Retighten the tie-rod nut. 5. Attach the snap ring of the tie-rod joint. B Draining Fuel Tank Water Loosen the drain plugs at the bottom of the fuel tanks to let sediments, impurities and water out of the tanks. Finally tighten up the plugs. (1) Fuel Tank (2) Drain plugs (1) Snap ring (2) Tie-rod nut 167 to 196 N-m (17 to 20 kgf-m) (3) Tie-rod joint A If the fuel contains impurities, such as water, drain the fuel tank at shorter intervals.
A Drain the fuel tank before operating the tractor after a long period of storage. B Cleaning Inner Air Filter Remove the inner filter, and blow air from the direction opposite to the filter's normal air flow. Pressure of compressed air must be under 205 kPa (2.1 kgf/cm , 30 psi). (1) Inner air filter (2) Push-rivet