STRUCTURE AND FUNCTION STEERING VALVE ! When the steering wheel is turned to the left, spool flows from port G to the head end of the right (3), which is connected by the spline of the steering cylinder. shaft, also turns to the left. The spool and sleeve The oil entering vertical groove B passes (5) are interconnected by centering spring (12), so through orifice b and flows to port J. From port the spool compresses the centering spring. J, it becomes the pilot pressure of the priority Therefore, a difference in the angle of rotation valve.
(angle variation) is generated between the spool and The oil from the head end of the left cylinder sleeve equal to the amount that the centering spring enters vertical groove D from port F and is is compressed. drained to the hydraulic tank. When this happens, first, port A and vertical groove 3. Steering wheel stopped B are connected. Then vertical groove B and port When the operation of the steering wheel is E to the Girotor, and port E from the Girotor to stopped, the difference in rotation between the vertical groove C are connected.
Finally, vertical spool and sleeve is returned to the neutral groove C and port G to the head end of the right condition by the reaction of centering spring cylinder are connected. (12). In addition, vertical groove B is kept connected to orifice b of port J to the priority valve, but port K of the sleeve gradually closes the connection of vertical groove B and port L. Port F from the head end of the left cylinder is connected to vertical groove D (connected to drain port H) at the same time as port A and vertical groove B are connected. !
By shutting off and connecting the above ports and grooves, the oil from the pump enters vertical groove B from port A, then flows to port E to the Girotor, and turns the Girotor. The oil discharged from the Girotor enters vertical groove C from port E, and 10-67