STRUCTURE AND FUNCTION STEERING VALVE ! In this way, the ports acting as the discharge ports of the Girotor are connected to the ports going to the steering cylinder, while the ports acting as the suction ports are connected to the pump circuit. ! Adjustment of discharge according to amount steering wheel is turned. For each 1/7 turn of the steering wheel, the inside teeth of the Girotor advance one tooth, and the oil from the pump is discharged in an amount that matches this movement. Therefore, the amount of oil discharged is directly proportional to the amount the steering wheel is turned. Role of centering spring !
Centering spring (12) consists of four X-shaped leaf springs and two flat leaf springs. It is assembled between spool (3) and sleeve (5) as shown in the diagram on the right. When the steering wheel is turned, the spool compresses the spring, and a difference (angle variation) is generated in the turning angle of the spool and sleeve. ! Centering spring (12) consists of four X-Shaped leaf springs and two flat leaf springs. It is assembled between spool (3) and sleeve (5) as shown in the diagram on the right. When the steering wheel is turned, the spool compresses the spring, and a difference (angle variation) is generated in the turning angle of the spool and sleeve.
As a result, the port of the spool and sleeve is connected and oil is sent to the cylinder. However, when the rotation of the steering wheel is stopped, the rotation of the Girotor also stops, so no more oil is sent to the cylinder, and the oil pressure rises. To prevent this, when the turning of the steering wheel is stopped, the action of the centering spring only allows it to turn by an amount equal to the difference in angle of rotation (angle variation) of the sleeve and spool, so the steering wheel returns to the NEUTRAL position. 10-69