Komatsu — AUTOMATIC PREHEATING CIRCUIT (Q.H.S. CIRCUIT)

STRUCTURE AND FUNCTION AUTOMATIC PREHEATING CIRCUIT AUTOMATIC PREHEATING CIRCUIT {QUICK HEATING SYSTEM (Q.H.S.) } OUTLINE ! To make it easier to start the engine in cold weather, a Q.H.S. (Quick Heating System) automatic preheating system is installed. This consist of a controller, a water temperature sensor, and a large capacity ribbon heater. ! The Q.H.S. automatically sets the preheating time to controller in the main monitor terminal CNL07-10 . The match the coolant temperature simply by turning the starting switch ON . It also acts to reduce the preheating and determines the length of time for lighting up the time. !

When the starting switch is turned to the ON position, the preheating pilot lamp lights up, and the ribbon heater carries out preheating while the lamp is lit up. The water temperature sensor detects the water temperature and it sends a signal from terminal 3 to the heater relay to the preheating time is set by the controller in the main monitor. ! While the preheating pilot lamp is lit up, preheating is being carried out, so keep the starting switch at the ON position. controller, the heater relay is turned OFF and preheating When the ribbon heater reaches a temperature which makes it possible to start the engine, the preheating pilot lamp goes out to indicate the engine can now be started.

! If the starting switch is turned to the ON position while the preheating lamp is ON , the current from the battery is divided to not only the starting motor but also to the ribbon heater,and might cause the engine not to start. Operation ! When the starting switch is turned to the ON position, A signal flows from the starting switch terminal BR to the controller instantaneously detects the water temperature preheating pilot lamp and the preheating time for the ribbon heater. ! Controller terminal CNL06-4 is connected to the ground, and lights up the preheating pilot lamp. At the same time, actuate the heater relay and make the ribbon heater red hot. !

When the preheating end signal is sent from the is completed. 10-133