Komatsu — STANDARD VALUE TABLE FOR ELECTRICAL PARTS

TESTING AND ADJUSTING STANDARD VALUE TABLE FOR ELECTRICAL PARTS 20-9 Sys- tem Name of Component Connector No. Inspection method Judgment table Measurement conditions Engine oil level sensor CNE2 (male) Continuity If the condition is as shown in the table below, the sensor is normal. 1) Turn starting switch OFF. 2) Disconnect CNE2. Engine oil level normal. Between (1) - chassis ground Continuity Engine oil level abnormal. No continuity Maintenance monitor Brake oil level sensor CNH2 (male) Continuity If the condition is as shown in the table below, the sensor is normal. 1) Turn starting switch OFF. 2) Disconnect CNH2.

Brake oil level normal Between (1) - (2) No continuity Brake oil level abnormal Continuity Engine oil pressure sensor CNE1 (male) Continuity If the condition is as shown in the table below, the sensor is normal. 1) Turn starting switch OFF. 2) Disconnect CNE1. Oil pressure normal Between CNE1 - Chassis ground No continuity Oil pressure normal Continuity Alternator Between alternator terminal R and chassis Measure voltage When engine is running (half throttle or above) ÿ 27.5 - 29.5 V i If the battery is old, or after starting in cold areas, the voltage may not rise for some time. 1) Start engine.