TESTING AND ADJUSTING MEASURING COMPRESSION PRESSURE MEASURING COMPRESSION PRESSURE When removing or installing the measuring equipment, be careful not to touch any high temperature parts. When measuring, be careful not to let your clothes get caught in any rotating part. 1. Before measuring the compression pressure, check the value clearances. Refer to “Engine Shop Manual” and adjust them if necessary. 2. Measurement conditions Engine water temperature: 40 - 60 E C (104 - 140 E F) 3. Remove the nozzle holder of the cylinder which is necessary to be measured. 4. Install adapter D2 and connect the compression pressure guage D1 5. Set the multi tachometer A.
Refer to “Measuring engine speeds.” 6. Cut off fuel control rod and then fix the governor lever of fuel pump to “no inspection” position. After that, measure compression pressure of cylinder while starting engine by starter motor. Do not crank the starting motor for periods longer than 30 seconds. Allow 2 minutes between the 30 second cranking periods so the starting motor can cool. i Read scale of compression pressure guage after being stable. i Measure and check the engine speed while measuring compression pressure. i After measuring, install the nozzle holder again. 20-14