TESTING AND ADJUSTING MEASURING ACCELERATOR PEDAL MEASURING ACCELERATOR PEDAL OPERATING FORCE OF ACCELERATOR PEDAL 1. Measuring 1) Set tool I at a position 150 mm from pedal fulcrum a . i Put the center of tool I in contact with a point 150 mm from the pedal fulcrum. 2) Start the engine, then measure the maximum value when the pedal is moved from the pushed position (low idling) to the end of its travel (high idling). 2. Testing 1) Stop the engine. 2) Disconnect the cable (1) at the bottom of the accelerator pedal, and check that the plate (2) and ball joint (3) at the bottom of the pedal move smoothly. i Carry out the above inspection, and adjust or replace parts if necessary.
Then carry out the measurement of the operating force again to check that it is within the standard value 20-17