TESTING AND ADJUSTING METHOD OF OPERATING EMERGENCY MANUAL SPOOL METHOD OF OPERATING EMERGENCY MANUAL SPOOL Outline The transmission valve is contrlled electrically, but if there should be any failure in the electrical system, or if there is any failure in the solenoid valve or spool and the machine cannot move, it is possible to operate the emergency manual spool to move the machine. This operation of the spool is designed only for use if the machine cannot be moved because of a failure in the transmission control, and it is necessary to move themachine from a dangerous working area to a safe place where repairs can be carried out.
This spool must not be operated except when there has been a failure. When carrying out this operation, keep strictly to theorder of operation and pay careful attention to safety when moving the machine. To prevent the machine from moving, lower thepbucket to the ground, apply the parking brake, and put blocks under the tires. Always stop the engine before operating the spool. 1. Remove cover (1) from the left side of the rear frame. 2. Remove lock plate (2) from emergency manual spool (3) of the transmission valve. i The lock plate can be removed simply by loosening the mounting bolts. 3.
Operate emergency spool (3) to the operating position according to the direction of movement of the machine (forward or reverse). i FORWARD: Push in the spool until it enters the detent. a = Approx. 8mm i REVERSE: Pull the spool until it enters the detent. b = Approx. 8mm 4. Check that the area around the machine is safe, then remove the blocks from under the tires. 5. Sit in the operator’s seat and depress the left brake pedal (4) fully. 20-24