TESTING AND ADJUSTING MEASURING TOURQUE CONVERTER, TRANSMISSION OIL PRESSURE 1. Measuring pilot pressure 1) Measurement port: 1 2) Start the engine and measure the pressure at high idling. 2. Measuring priority pressure 1) Measurement port: 2 2) Start the engine and measure the pressure at high idling. 3. Measuring all clutch pressure 1) Measurement port: 3 2) Start the engine and measure the pressure at high idling. 4. Measuring torque converter outlet port pressure 1) Measurement port: 4 2) Start the engine and measure the pressure at torque converter stall. 5. Adjusting modulating time Turn screw ( A ) to make the modulating time shorter or longer. 1) TIGHTEN screw to give PATTERN 1).
2) LOOSEN screw to give PATTERN 2). i The standard length is 6.75 mm (return fully, then screw in 4 1/2 turns). i Do not adjust excessively. After adjusting, always check that there is no abnormality in the pressure. i Keep the range of adjustment to within ± 1 turn. 20-23