TESTING AND ADJUSTING MEASURING TOURQUE CONVERTER, TRANSMISSION OIL PRESSURE MEASURING TORQUE CONVERTER, TRANSMISSION OIL PRESSURE i Measurement conditions C Engine water temperature: within white range on engine water temperature gauge C Torque converter oil temperature: 60 - 80 E C (140 - 176 E F) Apply the parking brake and put blocks under the tires. Preparatory Work i The following preparatory work is necessary when measuring all oil pressures. i Before starting the operation, check that there are blocks under the tires, then release the parking brake. C Remove cover ( 1 ) on the left side of the rear frame. C Check that there are blocks under the tires, then release the parking brake.
C Turn transmission cut-off selector switch ( 2 ) OFF and use the left brake. (Check that the pilot lamp is OFF.) C Remove the plug from the measurement port of the transmission valve. C Install hydraulic tester kit B to the measurement port, extend the gauge to the operator’s compartment, then start the engine and measure the pressure. i Check that no oil is leaking from any connection. i After removing the measurement plug, always coat the plug with adhesive. Plug: sealing agent (LG-1) 20-22