Komatsu — BLEEDING AIR FROM BRAKE SYSTEM

TESTING AND ADJUSTING BLEEDING AIR FROM BRAKE SYSTEM BLEEDING AIR FROM BRAKE SYSTEM Apply the parking brake and put blocks under the tires. Procedure 1. Raise the boom, set support (1A) or tool Q in position, then remove front cover (1). 2 . Remove cap (2) of the bleeder screw, insert vinyl hose (3) into the screw, and insert the other end in a container. 3 . Start the engine. 4. Depress the brake pedal, then loosen the bleeder screw and bleed the air. Keep the brake pedal depressed, tighten the bleeder screw, then release the brake pedal slowly. i Add brake oil when necessary during the operation to keep brake oil tank full.

come out with the fluid from the hose, depress the pedal fully and tighten the bleeder screw while the oil is still flowing. i Repeat the operation to bleed the air from the other cylinders, and after completing the operation, check th elevel in the oil tank and add more oil if necessary. i To bleed the air completely, bleed the air first from the cylinder which is farthest from the brake pedal. i After bleeding the air, carry out a brake performance test then bleed the air again and check that there is no air in the circuit. 20-37