Komatsu — TESTING AND ADJUSTING PARKING BRAKE LINKAGE

TESTING AND ADJUSTING TESTING AND ADJUSTING PARKING BRAKE LINKAGE TESTING AND ADJUSTING PARKING BRAKE LINKAGE Apply the parking brake and put blocks under the tires. Testing Depress the parking brake pedal with a force of approx. 294.2 N (30 kg). If the travel of brake pedal is more than 13 clicks, check for looseness of the control cable mount (pedal end and brake end). If any looseness is found, tighten and then adjust as follows. Adjusting linkage 1 . Pull release lever (1) and release the parking brake. 2 . Loosen locknut (2) and remove clevis pin (4). 3 . Set lever (5) at the parking brake end in the release position.

i With lever (5) at the FREE position, move the link up by the amount of play. 4 . Screw in clevis (3), align the hole with the pin hole in lever (5) at the parking brake end, then assemble clevis pin (4) and tighten locknut (2). 5 . After adjusting, depress parking brake pedal (6) with a force of approx. 294 N (30 kg), and check that the travel of the pedal is 7 - 11 clicks. If it is impossible to adjust only at parking brake end 6 . Loosen locknut (7) at pedal (6) end, then remove clevis pin (9). 7 . Screw in clevis (8) and adjust so that the mounting dimension is X . i Standard dimension X : 148 mm Adjusting parking brake switch 1 .

Adjust with nut (11) so that the mounting dimension at the tip of parking brake switch (10) is “ c i Mounting dimension “ c ” of switch: 4 - 6 mm i When doing this, check that the parking brake switch is OFF. 20-39