Komatsu — TESTING PARKING BRAKE PISTON STROKE

TESTING AND ADJUSTING TESTING PARKING BRAKE PISTON STROKE TESTING PARKING BRAKE PISTON STROKE Stop the machine on level ground, install the safety bar to the frame, lower the bucket to the gruond, stop the engine, then apply the parking brake and put blocks under the wheels. Testing i Check that the parking brake is applied. 1. Remove plug (1). 2. Insert tool S into the measurement port and measure dimension a from the end face of the cover to the piston. i Check that there are blocks under the tires. 3. Release the parking brake. 4. Insert tool S into the measurement port and measure dimension b from the end face of the cover to the piston.

i Piston stroke (X) = a - b If (X) 3.5 mm, the brake disc is worn, so replace the disc. i After measuring, check the transmission oil level. 20-40