TESTING AND ADJUSTING TESTING AND ADJUSTING BOOM KICK-OUT TESTING AND ADJUSTING BOOM KICK-OUT (IF EQUIPPED) Testing 1 . Stop the engine, and check that clearance b between switch (1) and plate (2) is the standard value. i Clearance b : 3 - 5 mm 2 . Start the engine, run at high idling, and check the actuation position. (Check three times and take the average value.) Adjusting 1 . Raise the boom to the desired height, and mark the boom at the position where the center of the switch is aligned with the bottom of the plate. Always apply the safety lock to the work equipment control lever. 2 . Lower the boom and stop the engine. 3 .
Align the marks and adjust the position of the plate so that the center of switch (1) is aligned with the bottom of plate (2), then secure in position with bolt (3). Plate mounting bolt: 88.3 ± 34.3 Nm (9 ± 4.5 kgm ) 4 . Adjust the switch so that the clearance between the detection surface of the switch and plate (2) is standard value b. i After adjusting, operate the work equipment and check that the kick-out is actuated at the desired position. i Clearance b : 3 - 5 mm 20-51