Komatsu — TESTING AND ADJUSTING BUCKET POSITIONER

TESTING AND ADJUSTING TESTING AND ADJUSTING BUCKET POSITIONER TESTING AND ADJUSTING BUCKET POSITIONER Testing 1 . Stop the engine and check that clearance b between switch (1) and angle (2) is the standard value. i Clearance b : 3 - 5 mm 2 . Start the engine, run at idling and check the actuation position. (Check three times and take the average value.) Adjusting 1. Lower the bucket to the ground, operate the bucket to the desired digging angle, then return the lever to HOLD and stop the engine. 2. Adjust mounting nut (4) of switch (1) so that clearance b between switch (1) and angle (2) is the standard value, then secure in position. Switch mounting nut: 17.7 ± 2 Nm (1.8 ± 0.2 kgm) 3.

Loosen bolt (5) and adjust the position of bracket (3) so that the rear face of angle (2) and the center of switch (1) are aligned. Bracket mounting bolt: 88.3 ± 34.3 Nm (9 ± 3.5 kgm) i After adjusting, operate the bucket lever, check that the positioner is actuated at the desired position, then secure in position. i Clearance b : 3 - 5 mm 20-50