Komatsu — MEASURING WORK EQUIPMENT

TESTING AND ADJUSTING MEASURING WORK EQUIPMENT MEASURING HYDRAULIC DRIFT WORK EQUIPMENT i Measurement conditions C Engine water temperature: Within green range on engine water temperature gauge. C Hydraulic oil temperature: 45 - 55 E C (113 - 131 E F) C Stop the engine, leave for 5 minutes, then measure for 15 minutes. C Boom: Horizontal C Bucket: Horizontal C No load A: Retraction amount of bucket cylinder rod B: Retraction amount of boom cylinder rod Apply the safety lock to the work equipment control levers. Never go under the work equipment. Measurement method 1. Set the boom and bucket in a horizontal position, then stop the engine. 2. Leave for 5 minutes, then start the measurement. 3.

Wait for 15 minutes, then measure retraction amount A of the bucket cylinder rod and retraction amount B of the boom cylinder rod. 20-49