Komatsu — ADJUSTING MAIN MONITOR (SPEEDOMETER MODULE)

TESTING AND ADJUSTING ADJUSTING MAIN MONITOR (SPEEDOMETER MODULE) ADJUSTING MAIN MONITOR (SPEEDOMETER MODULE) C The speedometer on the main monitor is a common part for all machines, and the input signal for the travel speed differs according to the machine, so it is necessary to adjust the monitor for use with the particular model. C In addition, the tire diameter also differs according to the type of tire fitted, so it is necessary to adjust to give the correct travel speed. C It is also necessary to change the switches if the optional E.C.S.S. (Electronically Controlled Suspension System) is installed.

Adjustment procedure C Turn off the power, then remove the main monitor and adjust the switches at the back of the speedometer. 1. Setting machine model 1) Remove the rubber caps from dipswitches (1), (2), (3), and (4) at the back of the speedometer. 2) When the rubber cap is removed, a rotary switch can be seen inside. Using a flat-headed screwdriver, turn this switch to adjust it to the settings in the table on the following page. 3) When the cap is removed from dipswitch (4) at the back of the speedometer, an ON/OFF switch can be seen. Adjust the setting if the E.C.S.S. (Electronically Controlled Suspension System) is installed.

Reference Amount of correction for switch (2) 4) After completing the adjustment, fit the rubber caps securely and install the main monitor. 20-53 Tire size Switch 1 (model selection) Switch 2 (speedomet er correction) Switch 3 (tachometer input selection) 17.5X25 Std. km/h 0 7 0 17.5x25 Std. MPH 8 7 0 20.5x25 Opt. km/h 0 2 0 20.5x25 Opt. MPH 8 2 0 Switch No. Switch 4 Without E.C.S.S. Without E.C.S.S. 1 ON ON 2 ON ON 3 ON OFF 4 ON ON Switch position 0 1 2 3 4 5 6 7 Amount of correction (%) +14 +12 +10 +8 +6 +4 +2 + 0 Switch position 8 9 A B C D E F Amount of correction (%) 0 -2 -4 -6 -8 - 10 - 12 - 14